R Programming language - R repeat Loop

www.‮aeditfigi‬.com

In R programming language, the repeat loop is a control flow statement that creates an infinite loop. The repeat loop executes a block of code repeatedly until a break statement is encountered within the loop.

Here is the basic syntax of a repeat loop:

repeat {
  # Code to be executed repeatedly
  if (condition) {
    break
  }
}

The repeat loop consists of the repeat keyword followed by a block of code enclosed in curly braces {}. The code within the repeat loop will execute repeatedly until a break statement is encountered.

Here is an example of a repeat loop:

x <- 0
repeat {
  x <- x + 1
  print(x)
  if (x == 5) {
    break
  }
}

In this example, the repeat loop sets x equal to 0 and then repeatedly increments x by 1 and prints its value. The if statement inside the loop checks if x equals 5 and if so, executes the break statement, which terminates the loop.

The output of this code will be:

[1] 1
[1] 2
[1] 3
[1] 4
[1] 5

The repeat loop is useful when you need to repeat a block of code an unknown number of times until a specific condition is met. However, you should be careful when using a repeat loop to avoid creating an infinite loop that may cause your program to hang. To avoid this, make sure that the condition for the break statement is eventually met within the loop.